Accessories for the 20-mm-hole grid
These adapters and stops fit directly into the hole grid of your workbench via a clamping bolt Ø 20 mm hole. You insert the part into the hole, tighten the bolt, and it’s securely held in place at a specific position. This way, you can use just a few parts to create exactly the clamping and stop configuration your workpiece needs.
Which part is for what?
- Fast and repeatable clamping: the eccentric clamp secures with a lever action—for repeated clamping at the same point.
- Aligning and positioning: the positioning angle provides a fixed stop edge for positioning and aligning the workpiece.
- Push off without slipping: The bench dog is the round version of the bench dog for 20-mm holes—a sturdy support edge for planing, sanding, and routing, featuring a laser-etched millimeter scale. A workpiece is also securely held between two hooks. Available with either a screw (S) or a tool-free clamping lever (K) fastener.
- Build your own jigs: Brackets and plates are the building blocks—secured with a clamping bolt in the hole grid, you can use them to create custom stops and supports.
Part of a comprehensive system
The clamping bolt Ø 20 mm is the same everywhere—which is why every piece fits on any table with a 20-mm grid: on the RUWI router table, on the table extension , on the Festool MFT, or on the Sauter Variobench. The vertical and horizontal toggle clamps, as well as the aluminum profile toggle clamps, all run on the same grid. You start with just a few parts and, over time, add exactly what your work requires.
